We used a 2 x 4 to estimate a comfortable slope for our ramp and we staked out an area just big enough to fit the concrete blocks.
Build a ramp for your shed.
The first step is to attach the ledger board to the front of the shed.
Cut the support beam to the right size ensure that it is horizontal and affix with screws.
This will save you a little time and excavation effort.
Pressure treated lumber rated for ground contact should be used to build a shed ramp.
Make sure the framing is not too far apart or the boards on top may sag over time.
How to build a shed ramp put it together cut your frame with the right angles from the slope calculations above.
When you ve cut the 4x4s to length lay them on the lip of the shed and mark the spots where the other ends touch the ground.
Attach a support plank to the exterior of the shed between the bottom of the door and the ground.
This will help to anchor the finished ramp in place and keep it from slipping away from the shed when under a heavy load.
A shed ramp is very handy for any backyard is you use a cart or want a better access to the construction.
The rise for sheds is often only several inches and riding mowers can easily handle a 1 8 slope.
There are two main things to consider for your shed ramp plans.
Therefore we recommend you to plan everything and to adjust the width and the slope of the ramp to suit your needs.
The down side is that the top and bottom edge of the sheeting will not be fully supported.
There are many ways to build a shed ramp.
Make sure to consider these when building a garden shed ramp.
Therefore 12 16 framing is appropriate for most shed ramps.
One alternative is to skip the ledger and end board and attach the ramp joists directly to the floor joist with metal hangers.
After that we dug a shallow 4 hole for the concrete blocks.
The nominal size of the boards you select depends on the ramp rise.
Use a circular saw to cut triangular stringers based on your rise and slope measurements.
The larger you make the gap the larger the bump at the end of the ramp.
It is essential to pour a concrete slab at the ends of the joists as you need to support them properly.
Along with slope and size there are a few other factors needed when learning how to build a shed ramp.
Front of the shed for the access ramp.
If you want a shed ramp that withstands heavy loads you will also need to think about additional concrete reinforcement on the ground.
The recommended distance is between 3 8 and 1 2.
The length of the ramp will be governed by the height from the external ground level to the shed floor and the slope that you choose.
A little bit of thought needs to go into the slope for two reasons safety and ease of use.
Next we measured the diagonal distance to the shed to check that it was square.
